RSR MY-64 Multimeter Case

Model is printed in PLA with no supports. There are supports already included in the model under the wire tabs that will need to be broken off. 

You will need the following hardware:

• (8) M3X6 to secure the bottom ribs to the bottom of the case
• (8) M3X3 to secure the top ribs to the top of the case
• (4) M4X30 for the clasp mechanism 
• (2) M4X40 for the hinge
• Super glue to secure the manual holder to the top of the case
• Super glue to secure the logo back to the top of the case