Circle Hole Box with Snap-On Lid!

This box features holes that add both simplicity and charm to its design. It comes with a snap-on lid that is not waterproof, allowing water to drain out through the holes. If you experience any issues, please leave a comment, and I will address them promptly.

 **Notes:** 1. If you’ve printed a box with a tight lid, sand the edges lightly for an optimal fit. Avoid over-sanding, as this can lead to a loose fit. Using a harder filament will enhance durability, but if needed, you can easily print a new lid.

 2. If you are working with soft filament, limit the number of times you open and close the box to prevent wear. 

**Important Note:** 

To resize the box, import both the lid and the box. Select both by holding the Shift or Ctrl key to choose multiple items. Once selected, use the scale tool to adjust their size as desired. 

If you like the model, give a tip to support Fonn Prints and help with future models and more! 

The dimensions for the boxes and lids are as follows:

 For Box V1 and V2XZ: 

- Length: approximately 39.7 mm

 - Width: approximately 25.8 mm 

- Height: approximately 25 mm

 For the Easy Open Lid:

 - Length: approximately 40.2 mm

 - Width: approximately 26.12 mm

 - Height: approximately 7 mm

 For the Tight/Water-Tight Lid

- Length: approximately 39.8 mm 

- Width: approximately 25.8 mm 

- Height: approximately 7 mm.