Inertial Santa Sleigh for Car

This is a Santa sleigh decoration for your car's dashboard that points in the direction your car is turning. Just glue together the parts and put in the bearing, and it's ready to put in your car. I just put double-sided duct tape on the bottom of the stand, and it stuck quite well to the dashboard.

NOTES:

• These are the bearings that you need: https://www.amazon.com/dp/B0CH2X65Y6?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_4&th=1 
• INSTRUCTIONS: Glue together the parts for the sleigh, but DO NOT glue the “Sleigh_To_Bearing_Adapter” part in yet. Push the bearing into the adapter BEFORE gluing the adapter to the hole in the bottom of the sleigh; it will make you life a little easier, trust me. You will have to use a little force to get the bearing to fully slide into the adapter; about half of the bearing should still be sticking out when you are done. Now you can glue the adapter into the bottom of the sleigh, then push the hole in the “Stand” onto the part of the bearing that is still sticking out. Your inertial Santa sleigh should now be fully assembled.
• I suggest using ASA filament so that the plastic won't soften when your car gets hot. (ABS can work too if you don't have ASA).
• This is for personal use only, so please do not sell or remix this.