SV08 Max Auxilliary Feeder top mount

This mount moves the Aux feeder to the top and is mounted using the screws for the top PTFE coupler mount. I recommend replacing all the couples and PTFE with a single piece of 3mm i.D. PTFE from feeder to hotend with no couplers. 

To use! You will need a 8" or so 4 pin extension cable. The connector is a Molex Micro-Fit 3.0 dual row connector. Buy on Amazon The wire should be what you have that is appropriate. If you have can bus cable that might be better.

Print in any material higher temp material (PLA-HT, PETG, ABS, ASA, Nylon, etc.) and at any resolution.