Qidi Q2 full width led mount

Let there be light! 
 

Simple led mount for Qidi Q2, angled at 45 degrees for optimal exposure. As you can see in attached pics there is waaay more light in the chamber now.

Installation is super easy, just unbolt three screws in the front part of the printer where original led strip is located. 

I have used 24V COB led which is soldered instead of factory one, you can use any led strip you like but make sure it is 24V - that is crucial.  Printed part is 33 cm long and it fits the whole space that is available. Most led strips won't allow for exact that length but it gives a bit of wiggle room. Mine was backed with adhesive.

Print in material that won't deform when exposed to heat from heated chamber.

Enjoy!