Peg board pliers rack

This is a pliers rack designed for pegboards with keyhole slots. It is compatible with both older or lower-cost pegboards featuring a 4.5 cm keyhole spacing, as well as newer models with a 3.75 cm spacing (such as those from Küpper).

As an optional upgrade, you can insert one or two magnets to ensure the holder doesn’t lift when removing the pliers. The recommended magnet size is 6 mm in diameter and 2 mm in height.

Print instructions

• PETg or similar. PLA might be good enough
• print stl file in given orientation without supports - or you can try the robust version in the 3mf with supports. But it might print not so cleanly. I chose the 3mf variant for max strength

Additional notes

I'm interested in your feedback to improve my stuff! So give me likes, post makes, comment and rate the print to show others and me how well it goes.
If you post a make, let me know which filament you use.

If you want to support me by donating a coffee go to https://ko-fi.com/antimaterie I would really happy about it. The money will be invested in all stuff regarding 3d printing to give more and better quality models.

In general my Prints are not for commercial use, but if you are a print farm owner and want to sell some of my stuff, please contact me.

Hope you enjoy my models.