BeaglePlay Case

This case holds a BeaglePlay single-board computer. To assemble it the way I did requires:

• 3 socket-head cap screws, M3 x 15 mm
• 1 socket-head cap screw, M3 x 5mm
• 4 heat-set inserts for M3, these are 6 mm long

There are also a set of alignment pins, if you want to verify fit before sinking any heat-set inserts.

To mount the external antennas, use the same recommendations from this model's progenitor, repeaed here to stand alone.

u.FL to SMA Extenders -

https://www.amazon.com/gp/product/B01HXU1PKS/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 

2.4GHz Antennas Used - https://www.amazon.com/gp/product/B088GWHNCR/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 

Sub-Gig Antennas - 

https://www.amazon.com/gp/product/B095JTW6XM/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 

or

https://www.amazon.com/gp/product/B086ZG5WBR/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 

Note on changes 2025-Nov-29:

• Increased cutout size for USB connector, extending cutout into bottom part.
• Moved cutouts slightly to better align
• Raised the interior pedestals slightly to give better clearance to surface mount connectors.

This model differs from the original design in that it:

• Made with FreeCAD for complete open-sourcing modifiability
• Accepts M3 heat-set inserts by default
• Screw holes are counterbored for socket-capped screw rather than countersunk
• Lacks the cool PCB antenna slots.
• Added a cutout for the JTAG programmer for CPU.