The adapter will accept a mil spec AR-15 buffer tube so you can mount any AR stock on your talon claw. In my test print the threading gripped the tube very tightly so the castle nut was not necessary but if you print with more clearance you might need the nut. If you have short arms this setup may not be comfortable for you because even with the stock completely collapsed the length of pull is as long as if it were completely extended on an actual rifle.
Printer Brand:
SeeMeCNC
Printer:
Rostock MAX v2
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
25%
Filament: Hatchbox PLA Black
Notes:
Supports might not be necessary because the threads are quite fine. Infill can be higher if you need more strength.
If you'd like you can buy me a coffee here: https://www.buymeacoffee.com/junrenman
The author marked this model as their own original creation. Imported from Thingiverse.