Over 23 different tuning parts for your 3018 CNC

Over 23 different tuning parts for your 3018 CNC
Look at the photos to see the functions
Printed with PLA or PETG

Have fun

I have printed:

3D printed components

2x limit switch holder X-axis
2x limit switch holder Y-axis
1x Z-axis limit switch holder
4x material clamps
2x load distribution plates for material clamps
6x end caps for the profiles
4x feet with foam for vibration damping
2x hand wheels for the X and Y axes
1x LED holder
8x cable clamps
1x touch plate
1x touch plate holder
2x power supply holder
1x XT30 connector holder
1x controller holder
2x power cord holder

Description of some components

Vibration damper for a 3018 CNC milling / engraving machine
Take the 20mm thick foam from the packaging and cut it to fit.
This works very well.
You can also experiment with different types of foam rubber for optimal cushioning.
Cut the foam a little bit bigger so that it fits into the holder without glue.
 

Limit switch holder for a 3018 CNC milling / engraving machine
Now a universal holder for X axis (left, right) and Y axis (front and rear)
The micro switch can be mounted in two different positions.
The holder for Z is fixed only with cable ties
Micro switch of type: "Micro Roller Lever Arm Open Close Limit Switch KW12-3 PCB

Clamp holder 
You need two long M5 screws or threaded rods and four M5 nuts to melt (with soldering iron) into the handwheels and holders. One M5 washer and one clamping block.
Saw off the head of the long M5 screw and glue the threaded rods with Loctite thread lock into the nuts.
With the rear screw you can adjust the height so that the holder is straight.
New, extended version 2 with 65mm length
Pressure plate to distribute the pressure on soft material.

Autolevel Probe Plate with Mount
This housing is designed for a autolevel probe plate / mount
The diameter for the contact surface is 30 mm
I have milled a 1.2mm thick circuit board
 

Simple LED lighting for 3018 CNC milling motor
Mounting with double sided tape or two screws
Screw spacing 15mm
Hole height 16mm from bottom edge

German:

3D gedruckte Bauteile

2x Endschalterhalter X- Achse
2x Endschalterhalter Y-Achse
1x Z-Achsen Endschalter Halter
4x Materialklemmen
2x Lastverteilerplatten für Materialklemmen
6x Endkappen für die Profile
4x Füße mit Schaum zur Vibrationsdämpfung
2x Handräder für die X und Y Achsen
1x LED Halter
8x Kabelklemmen
1x Tastplatte
1x Tastplattenhalter
2x Netzteilhalter
1x XT30 Steckerhalter
1x Controllerhalterung
2x Netzkabelhalter