Sunlu Dryer Mount for Printing TPU & FPLA on AnyCubic Kobra 3

I needed a way to better print TPU and FPLA on my AnyCubic Kobra 3 3D Printer. This design was made in a way that it disassembles easily letting you get back to printing with the traditional ACE setup when you are done. My Goal has been to make things easier to do with my AnyCubic and these printers can handle printing these materials with the right setups. 

FPLA FIlament Settings Suggested by Grok

Nozzle temp: 220–225 °C <<< Upper range and a little higher than Atariaxia Art suggests. 
Bed temp: 50–55 °C (first layer 55, rest 50) <<< Really Important

Brim – Optional if not sticking enough.

Please read my article about this design for more information: Printing FPLA on AnyCubic Kobra 3

Donations Appreciated: https://www.buymeacoffee.com/deskmouse

Sunlu Dryer: https://a.co/d/19WbFkO