Bookshelf Homelab Micro Rack

Instructions and other files to follow, just making the STLs available for now.

EDIT: New bits of info since original posting:

• Print all panels back to front.  For the pi panels, you will need tiny supports for the notch that fits into the supporting rail.
• The bridge struts need to be mirrored- there is not a file per strut.
• There IS a file per left/right right vertical struts, even though they are just mirrored.
• These were the passthrough jacks used; they snap into place. https://www.amazon.ca/gp/product/B09H5JZDLH/
• The single passthrough STL is for interest and is not needed to construct the rack as shown.
• The supporting rail for the pi panels was not present on first upload- you will need to grab it if you downloaded the files in the first few hours.
• All the trim (except for pis) is currently in one STL- will break it out when I can.