Use this adapter to mount a plug strip with to your Skadis panel. Supports rear keyhole slots, front mounting holes. M3 screw size. Two mounting points, separated by 50 mm. Use one or both.
Supports a variety of plug strips with the smaller M3 & 1/8" keyhole slots, including:
Anker Surge Protector Flat Plug Power Strip - Amazon ASIN B0DXPRK65X.
This can also be used to mount other types of screw mount fixtures to your Skadis panel.
Print Recommendations
25%+ infill, 4 wall loops.
Orient face up. Supports required (for counterbore).
Assembly
Install heat set threaded inserts - Uses two M3 x 5.7 mm threaded inserts.
Attach two M2.5 Slot Connectors to each plate. Use M2.5 x 16 mm buttonhead cap screws. These Slot Connectors attach the fixture to your Skadis panel. See https://www.printables.com/@HighDesertHacker/collections/2753370
Screws (typical) needed: M3 x 12
Installation
Refer to the photos. Insert M3x12 buttonhead cap screw(s) into the plate. Adjust the screw height to firmly fit into the slot of your plug strip (typically 2.5 mm gap). To lock the position of the screw, attach a nut and lock washer in the back of the plate. Place the fixed plate in your Skadis panel.
See other Skadis accessories at https://www.printables.com/@HighDesertHacker/collections/2753488
If it works for you, please Like and post a Make with photo to show others how you are using it.
The author marked this model as their own original creation.