Sponge Holder for Sink with Soap and Brush Spots

Sponge stand for behind your sink. Has spaces for a soap dispenser and a brush as well. The surface is grooved to allow for water runoff for easy drying.

The bottom of the stand has holes to insert legs to angle the stand for easy water runoff. I use 20mm legs in the rear and 3mm legs in the front. I also include a 7mm leg in case you want a lower angle.

8" wide by 5.5" deep… 200mm wide by 140mm deep.

My Creality slicer program says it takes 143.82g of PLA filament or a length of 48.22m.