Large Manual Turn Table for 3D Scanning/Displaying Models

This remix adapts the original design for a larger 10-inch top plate and includes an expanded base for greater stability and height.

Key features from the original design have been retained:

• The stand is designed to hold a standard 608 bearing.
• The top plate fits snugly onto the bearing.
• 4 access holes are included on the plate for easy bearing removal using a small screwdriver.

Please note that I did not create a rubber foot for this model yet.

I printed the base and plate in PETG, but PLA is also acceptable. 

Print Settings:

Print the plate laying flat on its surface.

Supports: Used for:

The 4 access holes (on the plate).

The flat underside inside the base.

10” plate and larger turning base