Nespresso Vertuo Pod Dispenser

I needed to store Nespresso Vertuo coffee pods on the inside of a kitchen cabinet door.  I spent days trying different designs before ending up with this solution, which has the following benefits:

• Holds a full box of 10 pods up to Mug size (XL and Carafe pods may work, but I haven't tested them).
• Consists of two parts - top and bottom - for printing on a 200x200mm print bed (rotate 45 degrees - see picture).
• Alignment features allow the two parts to easily fit together - a little superglue joins them perfectly.
• No supports required.
• Includes a pod recess feature which prevents the pods jumping out (vital if the holder is fitted to a cupboard door - prevents pod ejection even when slamming the door shut!). 
• Easy access to all pods in the holder - remove and refill in any order.
• Space-efficient: holder and pods project less than 55mm from mounting surface.

I used normal superglue to join the upper and lower parts, double-sided 3M foam tape to attach to the cupboard door.  Stack up several for extra storage!

These are very lightly loaded so normal PLA is fine.  Go for lower layer heights (e.g. 0.16mm) if you want the swooping curves to look nicer, but it doesn't really matter too much.