Qube 540 Back Cable Management Tray

Qube540 Back Cable Management Tray

Keep your setup clean and clutter-free with this cable management tray designed specifically for the Qube540 PC case. The tray mounts neatly to the back side of the case.

It consists of two parts that form a side cover, hiding cables when the PC sits on your desk to the right of you. This provides a clean look from the side view, concealing cables running behind the case. The included three hook versions help with cable routing at the top, middle, and bottom, keeping everything organized and out of sight.

Print settings for PLA :

• Material: PLA
• Layer Height: 0.2 mm 
• Wall Line Count: 3
• Top/Bottom Layers: 4
• Infill: 20 (Honeycomb or Gyroid pattern)
• Supports: required for tray clips.

Notice:
To print this tray, your 3D printer must support a minimum build height of 22 cm. Make sure your printer’s build volume can accommodate the full tray size before starting the print.

What’s Included:

Three Hook Versions for cable routing:

• V1 – Mounts at the top
• V2 – Mounts in the middle
• V3 – Mounts at the bottom

Two Tray Parts:

• Upper Tray
• Bottom Tray - this parts is almost 22cm in height on build plate

The upper and bottom tray parts can be glued together for a solid single piece, but since each has its own mounting pins that insert into the PC case, they can also be used separately without glue.