Stream Deck Module & Network Dock PoE Enclosure

The new Stream Deck Network Dock lets you use the Stream Deck anywhere you have an Ethernet cable! You don't have to be directly connected to your computer via USB anymore. This case combines the Stream Deck 15-key Module with the Network Dock into a single device that needs only a single Ethernet cable to power and connect it.

About

I was excited when I learned about the Stream Deck Network Dock, which lets you use the Stream Deck using Power Over Ethernet (PoE), and place it anywhere instead of being tied to the computer. If you have the big 32-key Stream Deck, the dock fits right in the stand, but it doesn't fit in the 15-key stand.

So, I decided to make this case to combine the Stream Deck Module and the Network Dock into a single device about the size of the regular Stream Deck 15-key in its stand. The Network Dock mounts inside the case, using the mounting bracket that it comes with. The Ethernet port is exposed on the right side. 

I didn't expose the USB power connection because I am using Power over Ethernet, so the one cable does it all. If you need the power port, feel free to remix! I have provided a STEP file. I put the Ethernet port on the right side of the case because that fit my application.

Printing

I printed this in Prusament Galaxy Black PLA on the Prusa XL with 0.4mm nozzle on the Image Shaper 0.2mm Structural preset. I used organic supports and 15% gyroid infill. All other settings were at defaults.

You may want to consider using a modifier in Prusa Slicer to bump up the number of perimeters around the two little screw holes in the bottom of the case for extra strength. I did this, but I don't think that's mandatory.

Parts Needed

You need the 15-key Stream Deck Module and the Stream Deck Network Dock. Elgato sells these as a bundle.

You also need a USB C cable with a right-angle connector on one end. I used this right-angle USB cable in the one-foot length.

You need two M3 x 5mm pan head screws. I used self-tapping screws but machine screws may work as well. I used thin washers, but those are optional.

Assembly Notes

To keep size down, space is tight inside the enclosure. See the photos for how I tucked the USB cable in.

I used M3 x 5mm self-tapping pan head screws with washers to mount the Network Dock bracket to the bottom of the case. Note that the spring tab on the bracket goes towards the back of the case. The module can be easily snapped in and out of the bracket once it's screwed into the case.

The Stream Deck Module sits slightly proud of the case by design. For some reason, there's a piece of copper foil tape on the back of the module, and that will be visible. I trimmed some of that tape off (see photo). If I had it to do over, I would have trimmed a bit more. I couldn't find any information regarding its purpose – I suspect it was there to ground the board to a metal case, but I'm not sure. If you choose to trim this tape, it's at your own risk.

The Stream Deck Module snaps into the top of the case. There are four locating bumps that mate with slots on the side of the Module. It is not very easy to remove once snapped into place. If you want to test fit it, I recommend doing so with the Network Dock not installed, so that you can stick a finger through the network port opening to carefully pop it out. 

On my Module, the little metal tabs on the bottom were bent outward slightly, which made the fit in the case even tighter. I bent them in a tiny bit with needle-nose pliers. Be careful doing this as it could apply too much force to the PCB.

Acknowledgment

I gratefully acknowledge user @shinwachi and their Elgato Stream Deck Module 15 Case as inspiration, and thank them for sharing the dimensioned drawing of the module that I used while waiting for my Module to arrive. Although I took inspiration from that design, mine is an entirely original model.