Utility dashboard - DIN rail mount / Anker Powerport / 5" ESP LCD

The dashboard uses a Guiton JC8048W550 module with an assortment of sensors. I plan to use it to control some lights and sorts.

The DIN mount holds a USB Power supply (Anker PowerPort 6) and acts as a riser to hold the screen outside the utility box. 

This dashboard runs an ESPHome firmware.

Hardware:

• M3 screws for mount and 2x heat set inserts.
• BT2.5, BT3 screws

Sensors:

• Can hold several 2.5cm QWIIC boards (you can stack two, for example), with slot for a light sensor.
• One slot for pimoroni BME680
• QWIIC cables
• Note that the tolerances are quite small for qwiic wire, but it does fit. I'll try to improve this.

Extras:

• I include a light pipe that can be printed on a resin printer and put in the slots on the left. It targets the default LED on one of the QWIIC board, but you can put your own too. I think it looks cool.

Thanks to the original creators whose work made the creation of this project much easier!

DIN Clip:

• Changed outer dimensions

Screen mount:

• Original model was optimized to be light weight, so I thickened the edges
• Added space for Adafruit QWIIC components
• Added mount holes for the dock