Parkside X20V TEAM Light

Parkside X20V TEAM Light with regulation

The print is a remix of Parkside X20V Team LED 10W Floodlight / Work Light on the thingiverse.com.

You need:

• Led Light 12-85VDC - aliexpress.com
• Over-discharge protection XH-M609 (I set protection 16V) - aliexpress.com
• PWM regulator DC10-60V - aliexpress.com
• Switch KCD1 - aliexpress.com
• Wire (I use red + and blue -)
• Connector faston male 6,3mm non-insulated 2 pcs- for battery connect
• Connector faston female 4,8mm 2 pcs(isolated recommended) - for KCD1 switch
• Bolt M4x16 4 pcs - for top
• Bolt M4X10 2 pcs- for light mounted
• Bolt M4x25 2 pcs- for mounted battery adapter to electronic case

Caution:

Wiring must only be carried out by electrical engineers!

The creator has no responsibility for any damage of the battery and other components!

My print:

0,28mm layer

30% infill

4 perimeters

4 bottom and top layers

Supports on the bed

For fix of eletronic parts I used small 5mm cylinders and glued it by hotglue gun.