European Building Tea light house Zamosc Ratusz (City Hall) Poland Polska

Add some European ambiance to your room or Christmas village with the historic city hall building from Zamosc, Poland. Designed to hold two LED tea lights or a small flash light underneath. Not to be used with real flame tea lights as typical filament plastics burn easily.

Two hollow versions remixed from my previous model. One with windows and clock cut open, another just plain hollow. 

Cheers / Na zdrowia! 

Printing tips:

• The plain hollow version is easier to print, less chance of stringing or print issues around the openings.

• No supports needed, to ensure the underside of the roof comes out ok, I recommend three walls/perimeters and set print setting inside to out so the first wall/perimeter prints on top of something.

• Printing without brim should be ok, I had a small amount of warping at the back corners, it was only slightly noticeable.

• Make sure you have good bed adhesion, there are many small isolated parts on the first layer.   

• If you feel it is too thin, especially if you scale the model down, use horizontal expansion (XY size compensation) ~1mm to thicken up the walls.

• I printed with 0.4mm nozzle in PLA.

Feel free to check out my other models in my Christmas Collection:

https://www.printables.com/@m_collectable/collections/2795376

Made two hollow versions: one with windows and clock cut open, another just plain hollow. Both can now hold tea lights underneath.