WAGO-221 Bandolier holder and lever-lock chain for 221-412/413/415

This is a bandolier and modular chain of snap-fit links that hold WAGO-221 lever nuts. Each link grips a connector and prevents the lever from opening, so the same link can be used independently inside your project to secure a connector, or snapped into a flexible chain for routing, staging, or quick access.

The chain assembles tool-free: print as many links as you need and snap them together. A starter/anchor link adds dual strain-relief and two screw holes so you can feed in lines or mount to a board. Make straight runs, circles, or a wearable bandolier to keep connectors at hand.

Mounting & routing: every link includes pass-throughs for M3/#6 screws and zip ties, so you can fasten links directly to panels, DIN plates, or frames, or lash conductors along the chain. The starter/anchor link also has two screw holes for fixed anchoring and dual strain-relief.

Tested fit: WAGO-221 221-412, 221-413, 221-415.

Use cases

Wearable bandolier for fast access on the bench/job site

Curved harnesses around panels or fixtures

Single link used as an in-project clip + lever-lock

Circular test ring for prototyping

Conveyor belt

Printing Tips:

ABS is recommended and print on the side.