Zelda Master Sword Repair Grip, threaded with replacement grip

remixed the file to add a thread also my handle was missing, so I printed a new one 
The thread is an ISO M18 18x2.5

printed in 0.4 Prusament PLA

How to:

1. Print the thread first, the model contains 4 parts, in your slicer split the model into those 4 parts and lay flat, no supports needed
2. If the fit is to thigh (depends on where your handle broke, just shorten the top extending pillars by roughly 5mm with some clippers
3. Print the fix ring
4. insert the 4 parts and roughly align the thread and use the fix ring to get the position right
5. the alignment is quite hard to get it right, so be patient
6. Add the desired grip on it
    

added a thread to be able to add additional grip