GIRO.HUE - Play Light Bar Mount

GIRO.HUE - Play Light Bar Mount

General

This bracket was designed to be mounted on back of the Philips Hue Play Lightbar Mount.

You will not need additional screws, nuts or washers. But if you lost the regular screw which comes included to the package then you will need the following screw.

Additional screws, nuts and washers per bracket

1x M3x5 with a Flat Head

Printing

I would recommend to use 3 or more perimeters. Print with a lower speed, for example 40 mm/s, to get a more accurate printing. I recommend to print the bracket with at least 20% infill to give it enough stiffness and prevent it from warping over time. I used Gyroid infill with the Prusa Slicer and works fluently for a longer time now.

Firmware adjustments

No Formware Adjustments needed.

Additional Information

Let me know if there are any kind of problems with the bracket. I will try to help and if neccessary correct the design. I appreciate any kind of feedback to this bracket.

If you like my work and find it really usefull then I would be very happy if you give me a small tip as an appreciation for my work.