Camera holder for Prusa XL original enclosure for right side
Can be used with any camera with 1/4 inch mounting point.
Hardware needed - M2.5 screws, 1/4 inch screw for the camera.
0
5
0
53
updated
October 31, 2025
Description
PDFCan be used with any camera with 1/4 inch mounting point. Tested with Logitech C920. Hardware needed - M2.5 screws, 1/4 inch screw for the camera. Optionally M3/M4 to the 4th hole.
The camera can cover most of the print area, just the corners does not fit.
Printed with organic support, but probably any other support will work.
Model origin
The author remixed this model.
Differences of the remix compared to the original
I mirrored the design to mount it on the left, then I added the holder to the bare mount, and substracted some material to fit the lighting.