Phone Holder for Life Fitness SL Console (at Planet Fitness)

This is a phone holder for Life Fitness cardio exercise equipment, using the SL Console variant of the display.

Given three widths of the holder, a 15mm, which you'd need two to hold the phone, a 60mm and 170mm. I modeled this after a few other examples.  Those examples were about 160-170mm wide.  I've found this not needed.  I initially was reverse engineering the holder from a picture and measurements that I did not take, so I printed 10-15mm versions, just for sizing and iterating over the design (as I didn't want to bring my caliper to the gym), however two of these also work well.  I ended up printing the 60mm and this seems to be just fine, and have not printed the 170mm version, as it seems unnecessary. 

The 60 and 170mm have slots in the lip that holds the phone, and should be large enough for lighting or usb-c charging cables. 

The rubber “Cabinet Door Bumpers” are required for the right fit.   The exact product I've been using is no longer available  on Amazon, however there are 100s if not 1000s of with names like Cabinet Door Bumpers or Clear Self-Adhesive Silicone Pads. 

Printed in PLA, (the grey is PLA+ 2.0), 15% infill of 3D Honeycomb - as you'll want them to flex a little bit. 

Fusion 360 files also included, so you can tweak the design as needed for phones or tablets … or wider … or … like a paper book.