Wall-mounted Scotch tape dispenser designed for easy one-handed use in workshops, offices, and maker spaces. It keeps the roll fixed on the wall so you can pull and tear tape with one hand while holding your workpiece with the other.
The design uses a shortened 150 mm hacksaw blade with coarse teeth for sharp, clean cuts; glue the blade into the slot for a secure and long-lasting cutter. The geometry is optimized so it prints in one piece with no supports.
The model is sized for standard Scotch-style tape rolls (25 mm inner diameter, typical office width). If your brand is slightly different, you can scale the model uniformly a few percent in your slicer. Print in PLA or PETG with 0.2 mm layers and at least 15–20 % infill for good stiffness. Mount with screws through the holes into a wall, board, or the side of a shelf.
The author marked this model as their own original creation.
