Blokees/Amiibo/Figure Stackable Display Shelf V2

Refresh of my stackable shelf design for figures cause now I have a pile of Blokees instead of Amiibos!

Base plate is now a bit thicker to better handle the weight, rods are now looser with a 0.3 tolerance between the pegs and the hole. 

Simply mix a match the rods and plates that you need.

Print And Assembly Advice

• When printing the rods, refer to the picture and make sure you print with the NARROW part of the connector peg on the print bed.
• When assembly the top plates do not apply force on the whole plate but rather focus on the connection point instead. Please watch the video as a guide so you don't accidentally crush the assembly.