Ryobi P119 18V Battery Charger Wall Mount Station

Was annoyed at this charger's inconvenience of just being placed onto a battery, so I made a wall mount dock for it.  Just press the charger into place, should be a good interference fit- then mount it to the wall! Two countersunk holes for wood screws.  Not crazy secure, but as long as you aren't like running into it should hold fine.   

I recommend printing with default basic tree support but it can be printed without supports as well, just some of the internal overhangs might be rough.  If its going in the garage probably use a filament that holds up to wide temp ranges.  

You can't see the charger status LED, but the battery lights do that job fine, and the charger is slow enough that everything is an overnight charge anyways.  Has not been tested with a battery >2Ah, but again the speed means you probably wouldn't want to anyways….
 

As a bonus, using this mount means you don't ever strain the charger's flimsy integrated cable.