Inky pHAT case (with RaspberryPi Zero)

Just a little case for the Pimoroni Inky pHAT (with RaspberryPi Zero).
The case can be clicked together without any screws.
The camera port, the SD Card and the two USB Ports are accessible, however, the HDMI Port is inaccessible.

Print instructions

I printed the case in a transparent PLA on the Mk3s with a 0.3mm Layer Height.

1. Put the spacer on the RaspberryPi.
2. Gently push the Inky pHAT onto the header. (without force)
3. Insert the assembly into the top part.
4. Insert the bottom plate on the header side first and maybe squeeze the sidewall a little bit with a flathead screwdriver outside to close up the case.