Shave Brush and Razor Srtand - 5 Brushes and 5 Razors

This is one of my first designs, so it may need work! 

• Brush Holes
  • 3 of the brush holes are 26mm,
  • The leftmost one is 33.5mm for a bigger brush.
  • The rightmost brush hole is 25mm, 
  • They are designed to hold and grip 30mm 26mm and 24mm brushes.
• Razor Holes
  • 4 razor holes are 11mm to hold standard razors.
  • Rightmost hole is 16mm to hold bigger razors (it will fit a Merkur Futur)

The square bottom cutouts are designed to hold the PAA shave cube base you can buy from Phoenix. 

The other cutout is for anything, but i made it to hold my shavette. 

The feet print separate, but I put .2mm indents on the base for them to sit in. These indents do not need supports. 

I printed this with PLA, and printed them on their backs (the 3 bars)

 I used tree supports for that. 

z recommend a big brim (10mm for me) and make sure your plate is ready, i ended up needing some adhesion. The whole print took about 25 hours, but i went slow using a .4mm nozzle with .2 layer height. I did 22% infill using Gyroid and 3 wall loops. Designed in Fusion 360