Parametric pantyliner box

This is a leightweight box which holds up to four different sets of pantyliners in a small space. Designed based on specifications by my better half.

I printed with the following settings:

• PLA
• 0.4mm nozzle
• 0.42mm line width (hence the 0.84mm walls)
• 0.2mm layer height
• wall loops: 1
• infill: 0% (you probably might want to add infill if you opt for a greater thickness of the parametric walls [which is unnecessary in my opinion])
• Ironing type: all top surfaces (or you can instead add a modifier which only covers the bottom and set ironing mode there, in order to avoid ironing of the walls' topmost surface)
• Fuzzy skin
  • Contour and hole
  • generator mode: displacement (extrusion has never worked for me so far)
  • noise type: Perlin
  • point distance: 0.3mm
  • thickness: 0.2mm
  • feature size: 0.3mm
  • Noise Octaves: 4
  • Noise persistence: 0.6

With ironing and fuzzy skin, print time can easily exceed 10 hours. Otherwise it should only need around 2 hours. Uses around 70g of filament with the default settings.