Anycubic Kobra 3 Cable Chain Start End for Upper Cord

This is a remix of JJ Irons Anycubic Kobra3 Cable Chain it improves upon the design by adding a more rigid start. 

I hope that you like this remix and if you would like to thank me for this you can tip me at https://buymeacoffee.com/deskmouse

I noticed issues with the original start piece in the set so I made my own version with improvements. 

This is a remix of JJ Irons Anycubic Kobra3 Cable Chain it improves upon the design by adding a more rigid start. 

Compare the creep and poor fit of the original on my existing make shown below:

See how much mor rigid this new design is and how it supports against deflection and strain from the moving cables.

I hope that you like this remix and if you would like to thank me for this you can tip me at https://buymeacoffee.com/deskmouse

Thank you and I hope that this helps you. 

What happened to me is the piece that Comes with the Printer breaks off after so many hours of running and it happened to both of my Kobra 3's about the same time.