4x 80mm Fan Bracket for 160mm AIO

Quad fan bracket designed for an Asetek C6J 160mm (Dual 80mm) AIO without fan mounting.

There are a few quirks:

• Long fan screws are recommended to hold this all together.
• Long screws must not be fully set until the shroud is full installed on the radiator. (Screws fit just past the lip, holding the radiator and shroud together)
• Printed part is VERY THIN and brittle, be careful taking off supports as to not break it.

Printing Settings (On my BambuLab P1P):

• Generic PLA + standard settings (I use a low power 13600T processor (Generally in 25-35°C range even under load), if expected to run hotter, use ABS/ASA for higher temp resistance)
• For best results print at 0.08mm layer height
• Supports:
• • Enabled
• • 45° overhang recommended
• • Tree supports not recommended (Use full standard supports)
• • Part is THIN, BE CAREFUL REMOVING SUPPORTS! Recommended to use angle snips to cut off supports.

Want to buy the AIO as well? I don't sell them, but you can get them REALLY cheap on Ebay. See link below, I will not be updating the link. https://www.ebay.com/itm/283850048518

How I Designed This

Reasons