seasucker 15x110mm thru axle (boost)

These plugs are designed to go inside a seasucker HUSKE mount and let you put your thru-axle bike on it. Highly recommend printing this as 100% infill as you want the part to be SOLID. Also recommend a brim and upside down.

I designed it to be a snug fit on the mount, if yours is too tight just remove some material so it can be inserted and removed easily but not that much that the adapter fells of the mount.

Don't use PLA as I did. I will get soft under the sun, ABS or PETG would a better material for this part.

Disclaimer: I am also an idiot ( just like this guy --> https://thingiverse.com/thing:3850759 ) and you shouldn't trust me. You are taking risks if you print something off the internet from a guy you don't know and then entrust your $5000 bike on your roof to it. Having said that, use at your own risk.

Print Settings

Printer Brand:

Creality

Printer:

CR-10

Rafts:

No

Supports:

No

Resolution:

.2

Infill:

100

Filament: Hatchbox PLA Yellow

Notes:

1. Print upside down it doesn't require supports :)
Don't use PLA since it can get soft under the sun, use a better material like ABS or PETG.

Post-Printing

If it is tight fit just use some sand paper to remove some material but not that much so the part fells of the mount.