ORICO USB Mount

I designed this solution to fit secure my USB hub to the bottom of my monitor stand in a way that allows the hub to be removed if needed. I found that my velcro solution was too flimsy. I have included the hub information in case there are any concerns. I am in Korea, and I am not sure if other regions have different model numbers for the same product or not, so please double check.

USB Hub Information

USB Hub Name: 7-Port USB3.0 HUB

Manufacturer: Orico

USB Hub Model: H7928-U3

Printing Information

No supports required

Printed with a 0.4mm nozzle

If the model does not appear with the large flat side on the print bed, please orient it to do so

Assembly & Notes

I used a thin double sided foam tape that is approximately 1.5mm thick. These need to be cut and placed in the 2 grooves on the 2 wings in the indentation. I had to cut 2 longer strips for each. The indent and the foam thickness causes it to sit almost flish to the bottom of the surface. 

The flexible part of the tab can be flexed enough to slide out the usb hub, but I found that the body also provides a bit of flex, so sliding in and out is not as cumbersome as one may expect.

If you have any comments or questions please leave a note and have fun printing!