Aeronaut Triple Thermic Hatch

This is a 3D printed version of the small hatches on the Aeronaut Triple Thermic RC sailplane.  The original is a friction fit, and generally needs to be taped on in order not to fall off.

Two variants are included:

• Exact reproduction
  • This should be printed flat on the side away from the rails
• Hatch with a thumb latch to engage and keep the hatch from popping off.
  • This should be printed on end, latch down, with a brim to avoid falling over.  This orientation is required to keep the latch from adhering to the hatch.