Clippy w/Stand

This may be just another Clippy, but it's a little different. I've modified the glasses (and eyes) orientation to be adjustable by unclipping from one side or the other. The can also be flipped to the other side to customize your view of the body. The iris will need to be glued to the whites, and the whites snap into the frames, but I recommend gluing the whites to the frames to secure them.

In the project file, I've set the pins to not be printed. I used the dowel setting and set the diameter to 3.1mm so that I could use 3mm (aka 2.85mm) filament to avoid a poor fit of the pins.  I'll use a long length of 3mm filament, put a dab of glue on the tip, and insert the tip into the hole. I then clip the length away leaving a short (<3mm length) sticking out. I do this for each pin on 1 half of the split part. Be sure to check that you've matched up the split parts with one another so that you don't accidently put the pins in both halves of the split part. (I did this once and had to reprint a couple of pieces.) To reiterate, don't put pins in both halves of the split parts.

I've left the face plates blank intentionally so that you can customize in PrusaSlicer with your own text or graphics.

For the body, I used a dual color filament, silver and gold. It's a great effect to have the contrast. I hope you enjoy this print as much as I do. Everyone I've shown it to loves it.

Remixes are welcome and encouraged. Please share here if you do. And, I would appreciate your likes and shares.  😊