MX-5 / Miata ND Spyder Grill Teeth

Vampire teeth for your ND Miata!

These will only fit the aftermarket Spyder Grill!

Just in time for spooky season, help you miot feed on something else than 92 octane and gearboxes.

The teeth print in two pieces and attach with zip ties, which can be up to 4mm wide.

For placement reference, see the picture. Print needs to be mirrored for the left side.

Printed in Sunlu PLA+ with stock preset. I added a strip of soft tape to the groove on the back to keep it from scratching the grill.

Installation:

1. Clip the grooved holder into the back of the tooth
2. Optionally: Add some tape or foam to the groove
3. Insert a zip tie from the top into the back of the groove, sliding the tip under the bridge so it comes out the bottom hole
4. Loop the zip tie tip behind the horizontal grill bar of the chosen spot
5. Tighten the zip tie so the groove slots over the grill bar
6. Cut off excess

Deinstallation:

1. ???
2. I haven't tried this yet