Nick's AllSky camera housing

I printed the parts from PETG, but you could try different materials. 3D prints are usually not watertight. To solve this problem, I sprayed the housing with Flex Seal Rubber Spray. The part called ‘AllSky cam TPU ring’ is printed with TPU. It is installed between the housing and the dome to ensure watertightness. Before installing it, you could apply some silicone grease on both sides. 

Additional hardware:

• Acrylic Dome:  https://www.amazon.com/dp/B08DY6DB7T
• 30mm 5V fan: https://www.amazon.com/dp/B0792BW2VH
• Raspberry Pi v4, HQ camera, and power supply (buy from your preferred supplier)
• Lens: https://www.aliexpress.com/item/1005002460250253.html
• Watertight Cable Gland: https://www.amazon.com/dp/B01MDTUIIA/ or buy from your local electronics store
• Fasteners: M2.5 and M3 Bolts, and Wood Screws in various lengths  (buy from your preferred supplier)
• Flex Seal Rubber Spray  (buy from your preferred supplier)