This is for the Magswitgh 95
Since the Magswitch mounting height is 3/4" and I use Baltic Birch (which is only 18mm) for my jigs which makes the switch sits proud of the base by 1.05 mm which is not a good thing. So I made a couple of shims.
1 is contoured to the match the Magswitch body and the other is a plain square shim that fits the body of the Magswitch but is square on the outside larger than the switch itself.
printer settings
nozzle .4
resolution .2
Nozzle temp 230
heat bed 85
Print with 3-4 perimeters PETG or ABS.
20-35% infill
no supports
https://www.prusaprinters.org/prints/143540-magswitch-150-shim-for-baltic-birch-18mm
The author marked this model as their own original creation.