Kitchen Aid Mixer Attachment Holder

Here is a modular solution for storing your Kitchen-Aid mixer attachments under your cupboards and out of the way.  Its an easy to print file, even though you must use bridges.

Print Setting (that I used)

Walls: 4
Infill: 35%

Top/Bottom Shells: 4

Attached is the Fusion file so you can remix.  I found that the tolerance on the attachments are not consistent, so you may need to change the height of the locking tab.  Just go into the parameters in the fusion file, and change be 1-2mm and you are set.  
 

Thanks for checking this out and I hope it works for you.