A PTFE guide clip for the Voxelab Aquila's extruder intake, intended for routing filament through a ptfe tube from a dry box.
I designed this part to be at the same height as this cheap dual gear extruder.
Requires 2x m3x6 (can be longer) to mount
I am still waiting on a longer ptfe tube to be delivered so no ptfe tube is in my pic but it does fit some capricorn 4mm OD offcuts I had so I think it should be fine.
Printer:
Voxelab Aquila
Rafts:
No
Supports:
No
Resolution:
0.16
Infill:
15
Filament:
Overture PLAGreen
Category: 3D Printer AccessoriesThe author marked this model as their own original creation. Imported from Thingiverse.