Sunlu S4 Stand (slightly more printable)

I liked this idea a lot, but the dovetails seemed like a huge waste of filament on supports, and the rounded bottom was going to make a saggy mess as it printed. I smoothed the back side to have a 45 degree slope up instead of immediately going into a curved fillet, and I replaced the dovetail connection with an overlapping slide-together connection (that I'm sure has a fancy name), with a few screw holes to screw it together with self tapping m2 screws, or to just glue it together.

Be sure to grab one of the drawers from the original upload page.

Replaced the dovetail connection with an overlapping screw/glue together connection for less support use.

Added a chamfer to the underside for better first layer.