Magnetized Hampton Bay Hawkspur 52 in. Light Cover / Diffuser

This ceiling fan has a ridiculously bright light/lamp, even on the warmest setting and the lowest brightness. 

The cover is 10" in diameter at its widest, which is too wide for a Prusa MK3s+, but will just barely fit on the build plate of a Bambu P1S.  The ring is 3/8 inches wide.  Color is Inland / Micro Center Tough PLA Denim Blue.  Magnets are 5x3.  There are 3 pressed and glued into each hole.  24 magnets needed total.  The ring cover has a very good snap / connection to the ring of the ceiling fan.

The light shields are 9" in diameter and set to 0.12m in height.  Scale the model to your preference.  I recommend setting the height to .4mm and first printing a two layer shield to test the dimming / diffusing amount.  Color is factory Bambu Orange from the trial pack.