Derpy Tiger (KPop Demon Hunters)

Derpy is a friendly yet slightly scary character from the movie KPop Demon Hunters. It is a big feline with blue fur and big yellow eyes. He seems to be obsessed with turning objects back in place when they get knocked down.

Designed on Nomad Sculpt, the model prints easily without supports. 

Now including a little flower pot. Just knock it over and it should get his attention immediately! :D 

Printing Advice

It's a simple print, no supports needed.

• 0.20mm (speed)
• 10% infill
• brim enabled - not necessarily needed, but depending on your environment it can prevent warping

I also painted some of the seams so it didn't run through the face of the model. This is included in the .3mf file.

You can use the same settings for the flower pot. Scale to your needs!

Finishing Tips

I painted the model using The Army Painter paints, after a good layer of primer for plastic. I finished with a matte varnish spray, and then I applied top coat gel nail to the eyes only and cured on a UV lamp for a glossy effect! This is a cheap way to get glossy details on your prints. Just make sure it's a “no-wipe top coat gel polish”.