Magsafe desk stand

I made this after trying a couple of other stands I downloaded that didn't quite satisfy me.

This attempts to address the following 3 issues I had with other stands:

• The magsafe circle is very close the camera bump on my case (Apple's tech woven case). Other stands would not let the phone sit flush because of having material above and on the sides of the charger. This is addressed by having the top/sides be exactly the size of the magsafe charger.
• On other stands, the magsafe puck would come out as I pulled the phone. To address this, the circle is intentionally tight with the openings on top and sides giving it enough flex to press fit the charger, while giving you plenty of access to pull it out easily if needed.
• Angle at which it sits. This is a very personal preference after using the same store bought stand for years. I found other stands to be too vertical so this sits at around a 60º angle from the table which is comfortable for me to see and interact with.

Although I saw other models that could address one or another issue, I don't think I found any that satisfied all.

Made to hold an iPhone Pro model but should work fine on other iPhones.

I printed with 25% infill and it's plenty sturdy so it can probably be printed with less infill. Needs supports for the channel for the cable and possibly for the back curve. I just used automatic supports.