Voron Magnetic Door Hinges

Made this to add to my stealth changer (SC.0195) to make servicing easier. All of the other magnetic doors I found required tape and I didn't like that. This model uses m5 screws directly through the door to prevent slipping. I found that with n52 6x3mm magnets 2 hinges per door was plenty on my 300mm V2.4

BOM (Per hinge):

four 6x3mm magnets

two m5 x 12mm screws

two m5 nuts

one/two drops of superglue

Steps:

1. Print 1 door part and 1 frame part per hinge
2. Install magnets being carefull of polarity
3. Print drilling template
4. Drill holes in door
5. Screw on and enjoy