Mount to use Slice Engineering Mosquito and Magnum hotends with the Precision Piezo Orion z-probe. This is the bottom part of the Orion mounting system only - the upper section does not change whether it be the groove mount, direct, or other. See the official Precision Piezo files at https://www.thingiverse.com/thing:2841681 for remaining part(s). There are
There are multiple variants for mounting the hot end and tensioning the piezo. Two mounting methods are provided - heat set brass inserts or self threading screws. While less common, the screws are a signficantly more stable method. The mount can be connected to its base in two ways as well - a traditional, all printed part and an alternate which uses o-rings to help fine tune preload and calibrations. More details on the o-ring option from the designer ajcraig at https://www.thingiverse.com/thing:3122283
STEP files included.
| Description | Link | | --- | --- | | M2.5 x 4mm Brass Threaded Insert | https://www.amazon.com/gp/product/B01N8QX6RX | | Thread-Forming Screws for Thin Plastic | https://www.mcmaster.com/96817a894 | | Capricorn XS PTFE tubing | https://www.captubes.com/shop/#!/XS-Series-Ultra-Low-Friction-PTFE-Tubing/c/23214267/offset=0&sort=normal | | M3 Bolt | 8, 12, 20mm use spares from Kit or self-source |
PETG/ABS are preferred material. In order to function properly this portion of the Orion mounting system works best with a small amount of flex. PLA is possible but stiffer than desired. Note the upper section should be as stiff as possible.
Prints without supports. Any supports are likely to get stuck in the small brass insert holes, and internal supports will impede the small amount of flex the Orion needs to function properly.
| Description | Link | | --- | --- | | Railcore II BMG + Precision Piezo Orion - Printed Carriage | https://www.thingiverse.com/thing:3240565 | | Railcore II BMG + Precision Piezo Orion - Aluminum Y-Carriage | https://www.thingiverse.com/thing:3461186 | | Sice Mosquito/Magnum Precision Piezo Orion Mount | https://www.thingiverse.com/thing:3456684 | | E3D v6 Precision Piezo Orion Mount | https://www.thingiverse.com/thing:3646599 | | Railcore II Drag Chain | https://www.thingiverse.com/thing:3582159 | | Railcore II Aluminum Y Carriage Belt Retainer | https://www.thingiverse.com/thing:3597877 | | Railcore II Fan Adapters | https://www.thingiverse.com/thing:3646685 | | Railcore II Part Cooling Fan Support Bracket | https://www.thingiverse.com/thing:3598226 |
Printer:
Railcore II
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20%
Category: 3D Printer PartsThe author marked this model as their own original creation. Imported from Thingiverse.