Extended Sliding Keyboard Tray

I wanted a deeper tray for my large ergonomic keyboard so extended the sliders to be able to accommodate a 25" long x…
8
38
0
410
updated March 1, 2022

Description

PDF

I wanted a deeper tray for my large ergonomic keyboard so extended the sliders to be able to accommodate a 25" long x 11.75" wide x 5/8" thick MDF board. The board does extend a little bit off the back of the sliders but still seems to work fine. I attached this underneath my VIVO standing desk using #6 5/8" wood screws. Time will tell if the PLA will hold this larger tray!

I used the same brackets and instructions as the original model by savingprivatebrian15 (check that out for more details on installation).

Print Settings

Printer Brand:

Creality

Printer:

CR-10

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

75%

Filament: eSun PLA+ White


Notes:

I've had some of the pieces break with 50% infill so have bumped this up to 75% (hopefully it holds).

Category: Office

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License