This jig is used to make consistent length magnetic ball joint arms for the Cerberus, Cerberus Pup, and other Rostock deltabot printers.
Requirements:
Print two and mount them onto a length of wood at appropriate distances using screws.
NOTE:
The way I did it to keep the epoxy from getting all over the place is I glue one ball at a time using the following procedure:
When you do the second ball, rotate the jig so that the second ball is now at the bottom and repeat steps 1-8.
What this does is uses gravity to let the epoxy flow down to the ball and stick to it. It's slow, but it works. :)
Category: 3D Printer PartsThe author marked this model as their own original creation. Imported from Thingiverse.